Gas Detectors
As an authorized service station of RKI Riken Keiki and BW Technologies, MARINE SAFETY provides technical calibration with minimal turnaround time. Using the proper tools and expertise, MARINE will inspect and calibrate all detectors before returning them with a new compliance certificate. We also service other brands of detectors.
We are authorized and certified service station for: RKI and BW Gas Detectors.
- Verifying the proper function of a detector; performing any necessary calibration; issuing a new certificate of compliance.
- Quick turnaround to suit the vessel’s needs.
- Maintaining validity of compliance certification; notifying the device’s owner of pending certification and recalibration of the detector.
- Providing additional onboard detectors as needed by the vessel.
- Ongoing technical assistance.
Tube Measurement System
The Tube Measurement System consists of a Tube and a Tube-pump. Each tube contains a very sensitive reagent system that produces accurate readings when the technical characteristics of the gas detector pump precisely match the reaction kinetics of the reagent system in the tube. Therefore, a gas detector pump, delivering the correct volume must also pull the sample through the Tube at the proper rate. These requirements are referenced in international as well as national detector tube standards or norms which require or recommend that detector tubes be used with a matching gas detector pump from the same manufacturer.
We supply the world’s most reliable tube systems:
Dräger, MSA, Kitagawa.
- Risk of explosion
- Oxygen displacement / oxygen excess
- Toxic gases
Ullage Temperature Interface UTI
The portable Ullage-Temperature-Interface (UTI) oil/water detector is provided for rapid and accurate determination of the oil/water interface in slop tanks. UTI detector is also used in other cargo tanks where the separation of oil and water is effected and from which the discharge direct overboard is foreseen.
We provided calibration services for UTI top brands.
- Temperature Sensor Calibration
- Gauging Tape Replacement (With or without new sensor attached)
- Hub Cover and P.C. Board Replacement